Single Saws

Chop Saw SW400
Saw blade Ø 400 mm (15.74")

The intermediate degrees can be obtained by manually setting mechanical stop.
Manual rotation of the working table, up to 45° both toward right that toward left.
It is able to be tilted on the left side up to 45° (vertical axis).
Automatic locking of cutting angle at 90°, 45°, 30°, 15°.
The intermediate degrees can be obtained by manually setting mechanical stop.
Integrated guard for blade protection

Blade feed by mean of hydro‐pneumatic unit.
Quick positioning of the working table on pre‐selected angles (135°, 90°, 45°).
Manual positioning at any intermediate angle, with pneumatic locking.
DIGIT = Digital display for the angular positioning of the cutting plane, on request.
MQL System = Lubrication tool with Minimal Quantity Lubrication.
The structure foreseen for the support of the profile is shiftable manually, to increase the cutting capacity at 90°.
Protective hood of the cutting zone with pneumatic drive movement.
Pre‐arranged to connect an exhaust extractor for swarfs.

Blade feed by mean of hydro‐pneumatic unit.
Quick positioning of the working table on pre‐selected angles (135°, 90°, 45°).
Manual positioning at any intermediate angle, with pneumatic locking.
DIGIT = Digital display for the angular positioning of the cutting plane, on request.
MQL System = Lubrication tool with Minimal Quantity Lubrication.
The structure foreseen for the support of the profile is shiftable manually, to increase the cutting capacity at 90°.
Protective hood of the cutting zone with pneumatic drive movement.
Pre‐arranged to connect an exhaust extractor for swarfs.

Blade feed by mean of hydro‐pneumatic unit.
It’s able to perform cuts at 22,5° or 45°, 90°, 135° or 157,5°
Manual positioning at any intermediate angle, with pneumatic locking.
Total isolation for the noise reduction and the elimination of any other risks.
Wide cutting capacity by means of sawblades with diameter of 550 mm (21.65")
All the working scraps are carried in the middle of the base.
Protective hood of the cutting zone with pneumatic drive movement.
Possibility to use a blade with a dia. 550 mm, with lowered tool rotation centre (SW 550-R).